Search the Community

Showing results for tags 'analog input module'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Found 81 results

  1. I am working on Remote IO panel and plan to use the following components: 1734-AENT 1734-OW4 - qty 2 1734-IE4C I wonder if I need to separate the bus between the relay output module and analog input module? Or anywhere else in this setup? Thanks.
  2. Hey guys. New to the forum and new to plcs. I am running into problems quick, fast and in a hurry. Please be patient. I have created a new project. I have added module 1756 ENBT because that is what I will be connected to. On the chassis there is another ether net card which runs to a switch. That switch runs to a 1734 aent card. I have added this module, 1734 aent, as well to my project. Now I must add a 1734 IB8S and a 1734 OB8S. These are not appearing in my list. I proceeded to download and install these add on profiles. After installation, however, I can still not select the I/O modules. Why is that? And how do I fix it? Thanks in advance, HotPie
  3. I need to set up D/A module. I have few questions. What is the difference between offset and gain setting mode? I would like to use range 0 to 10V which would have to be set as user range setting, can I do it using GX Works 2? Or do I have to use the GX Configurator-DA package?
  4. Hi everybody, I am new in these issues and I have faced a problem that is driving me nut. I am building a mixing batch HMI and its PLC program. In my HMI I created an analog tag that stores and integer number. This tag is responsible to comunicate with an analog input of the PLC I/O expansion module, whose address is I:1.0. In my HMI I put a numerical input box to send values to this analog input, but every time I write a value in this box and press the enter key the numerical input box gets red and don't send the value to the plc. Appear the following error message "cause: Addressing problem or memory protect rungs" on the left botton corner of the HMI. Some pictures are annexed to describe better. Anybody knows what can I do? I am using PLC SLC 5/03 + Analog module 1746-NI4
  5. Using GX Works 2

    Hi all, Just joined today and was browsing through this forum. Now I need advice/help. I have installed the software to read an FX PLC. It worked okay yesterday. I was going through a program printout that I downloaded and couldn't see where the X inputs were in the program. So, I thought i'd go back in and get the program again. I connect to the FX fine. It passes the test and then I connect. The screen comes up entitled "Online Data Operation". I select "All" and hit the execute button. Wait about five seconds and then I get an error: "The Device Data Name is Empty". Okay. I go to put a name on the "Title" box and it WILL NOT TAKE KEYSTROKES. Gaack! :helpme: I have restarted the program and laptop several times. No matter what i do it will take keystrokes in the "Title" bar. I cannot get the program. Any thought? The only thing I can think of is to reload the program but that takes quite a while. Old stuff is fun to work on.
  6. ML1500 Analog Smoothing

    Hi All, Im sure this has been covered before... Im using a ML1500 and a 4-20ma output flow meter. Due to the erratic flow in the line the analog signal is all over the place. What is the best way to smooth this signal out so I don't see all these variations..??? I don't have a CPT instruction on the ML1500 but there has to be a way. Just looking for the way you guys do this that gives you the best results. Thanks