simple motion module setting tool how to set electronic gear in module QD77MS2

[diraemon 2]

hello everyone,,,, I want to running the motor in 100 rpm but how to setting electronic gear to control speed in servo motor HG-SR502,, does anyone know how?

[glavanov 33]

Positioning data-->1 Axis speed control-->speed value= [(pulses/rev*100)/60sec.= sulses per second(rpm)]

This is for pulse units system.

As i recall, electronic gear can be used only in synchronous control settings... 

Caution for Pr.21 in module parameter settings!

Edited 13 Feb 2019 by glavanov

[diraemon 2]

On 2/13/2019 at 2:09 PM, glavanov said:

On 2/13/2019 at 2:09 PM, glavanov said:

Positioning data-->1 Axis speed control-->speed value= [(pulses/rev*100)/60sec.= sulses per second(rpm)]

This is for pulse units system.

As i recall, electronic gear can be used only in synchronous control settings... 

Caution for Pr.21 in module parameter settings!

Positioning data-->1 Axis speed control-->speed value= [(pulses/rev*100)/60sec.= sulses per second(rpm)]

This is for pulse units system.

As i recall, electronic gear can be used only in synchronous control settings... 

Caution for Pr.21 in module parameter settings!

thx you mr. @glavanov