Logan1101

MrPLC Member
  • Content count

    10
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Logan1101

  • Rank
    Sparky

Profile Information

  • Gender Male
  • Country United States
  • Interests Industrial & Agriculture Maintenance
  1. YASKAWA v1000 plc

    Over the past couple months we have had 5 Yaskawa v1000 CIMR-VU2A0002FAA VFD go bad. While this is only a small fraction of how many we have its still alot to go bad when the line is only 8 years old.  They got a ol1 fault. Investigate, find no issues with the motor and wiring. Replace the vfd and the problem goes away for good.  Is something causing these vfd to go bad or did Yaskawa simply produce bad vfd 8 years ago.  Only experience with VFD is Mitsubishi VFD and they seem to last forever.  Background information.  208 v 3 phase (Input and Output) Used to power 2 foot section of conveyor moving engine heads.  Motor= Baldor IDGMP2503
  2. Slow Dell Laptop

    My current work laptop is and Dell Inspiron 15 3000. It is super slow, and I am unable to upgrade the laptop (Due to the company), but I can upgrade its cpu/ hardwire. The Processor & Memory:10th Gen Intel® Core™ i7-1065G7 Processor 1.0GHz12GB DDR4 2666MHz RAMDrives:1TB 5400 RPM SATA Hard Drive. I wanted to upgrade the cpu to something that is faster than a 1.0 GHZ and while the company is giving me money I don't want to halfass and upgrade on it. What CPU is compatible with my laptop and can handle all the different software that I attempt to run? 
  3. Got 2000 GT2715-xtb

    HOW DO I ENABLE GS668? IT WON'T LET ME USE GS668 IN THE PLC, BUT CAN YOU EVEN WRITE LOGIC IN GOT OR.?.?.?.? I HAVE NEVER MESSED WITH ANY INTERNAL BITS BEFORE SO I AM CONFUSED HOW TO DO ENABLE GS668 IN ORDER TO GET THE SOUND TO ENBLE UNDER PROPER CONDITIONS.
  4. PLC to PLC

    If I remember correctly, I was told by a Mitsubishi rep. that Q03UDE plc cannot communicate with each other unless one of them has an additional Ethernet module. So either you need to add an ethernet module to one of the plc racks, or upgrade plc. I believe Q03UDV is capable. I would contact a Mitsubishi rep for confirmation on that. Best of Luck
  5. Got 2000 GT2715-xtb

    I want to write logic in my plc (q03ude) to turn on the buzzer/horn (whatever you would like to call it). That is built in the GOT. Is there a special register todo so. If so what is it and how do I find the list of special registers
  6. Weekly Timer

    Is that the same as q series plc as well?
  7. Specific Time to energize an output

    Yea because there is definitely not a way to reset a latch. 
  8. Specific Time to energize an output

    Looking to set a latch at 5am every morning to start a process Fx3u.
  9. Wanting to know if you could set a Mitsubishi Fx PLC to energize an output and/or coil at a specific time? Looking to automatically start a process when 5am hits.