Search the Community

Showing results for tags 'remote mode'.

  • Search By Tags

    Type tags separated by commas.

  • Search By Author

Content Type

Find results in...

Find results that...


Date Created

Last Updated

Filter by number of...

Found 55 results

  1. HMI Transparent Mode

    JanHrust posted a topic in Mitsubishi

    Hi all. I currently have a scenario where I connect with a SCADA (OPC using virtual com port) to an Controller (A-series) via E300 HMI using transparent mode. This setup works fine, no problems. I have now upgraded the E300 to the E1032 HMI with all the same settings, except the E300 was using an expansion Ethernet card and the E1032 is using the built-in Ethernet port. Now with the E1032 in place the SCADA (OPC) just cannot get healthy comms to the A series PLC. Am I missing something somewhere?

  2. 1747-AENTR

    Vitor Prado posted a topic in Allen Bradley / Rockwell Automation

    Hello, would like to change some ideas with you. I´m working in a new project and need convert an SLC500 to Controllogix, with a 1747-AENTR is possible create a SLC500 Eth remote.... but in my case i have two 1746-A13 (conected by expansor) and can´t add all the modules in a rslogix5000 aplication. In the 1747-AENTR manual say that is possible in the v21.00 of the rslogix5000... I really need install this new version? Don´t have other way? Thank you! Vitor Prado
  3. I am working on Remote IO panel and plan to use the following components: 1734-AENT 1734-OW4 - qty 2 1734-IE4C I wonder if I need to separate the bus between the relay output module and analog input module? Or anywhere else in this setup? Thanks.
  4. Hello, I'm working with some old Allen-Bradley SLC5/04 systems with 1747-SN modules. The module is located in Slot1. One system is only using the RIO module for a PV1000. How do you know where the "M-Files" for Analog I/O modules and/or Panelviews are located? I see programming using locations such as: M1:1.810 where 60 words are being copied from a Remote I/O PV1000 to some words for the SLC to utilize, but I don't understand why "M1:1.810" was used instead of, for example, "M1:1.800"? I looked and so far cannot find information pertaining to the words other than what is in the User's manual, and it doesn't address this issue. The panelview in my example uses all of Logical Rack 0, Full Rack addressing. Any help would be most appreciated. I have very little experience with the RIO stuff because almost everything I've worked with in the past has been Devicenet.
  5. I need to change the IP address of an existing PLC. Only access I have is remote (VPN). Is there any issue with downloading the same program - with the IP address changed - to the existing processor? Then change the local network range to match, etc...