ceilingwalker

If I have a @SUB(31) instruction, does the @ indicate a single-scan condition, as Jay mentioned above?

This is going to sound like a very vague question but......could any of the wiring have been changed, that could do this? I have power to the Power supply (C200HW-PA204C). I have no drawings of any kind to compare with. They bought this old junk with no documentation of any kind. 

What's odd is, I don't have any LED's on for my input module and my motion card LED isn't on. These are all powered by the backplane, correct? I would think that even if the CPU had issues, those should still be lit, since they are still attached to inputs?

Also, is my assumption that the error LED is solid because of program loss to the CPU?

Oh, the tech I talked to at Omron yesterday didn't mention turning switch 4 off, only turning switch 5 on, to use the 9-pin port instead of the peripheral port. I will try this. Also, do I use just the CN22-EU or do I need to use a second cable as well, like I did to upload from the NT630C? 

Hello, I have an CS1G that I went online with a couple of weeks ago and uploaded the program. The other day the electrician killed power to the cabinet and it has been off for 2 days. I am no longer able to go online (RS232) with the CPU. Since the remote I/O module is no longer blinking I am fearing  that it poop'd its memory. I am trying to re-load the program however, it will no longer allow me to go online with the CPU to do so. I am assuming I might have to mess with the dip switches on the front, to put a new program in it?

I have followed your steps above and am having no luck. Could I ask which cable you are using? It appears (according to the manual) that the NT25 is pretty much the same as the NT31. 

Did you use a DB9 to USB converter?

Hello, I have an Omron touchscreen I am trying to upload data from. It is an NTH25. The NT is connected to a CS1G cpu44. I have software that Omron Tech support sent me the link to (NTST4.8E). I using the pinout for an CSM_XW27 cable connected directly to my laptop. I have tried everything I can think of (making sure coms params match) but I can not get the NT to respond. I followed the steps in the booklet and have the NT so that it is displaying "Please Transmit". Any other advice would be awesome. Thanks.

Hello. I have an NJ101-9000, using NX I/O, using Sysmac Studio v. 1.13. I have an input that I am trying to scale. Because it is an INT I am using 0-32,767 and 0-8000 is the input for this proportional valve. I have attached below, what my function looks like, and the error I keep getting. My first Sysmac Studio project, but am accustomed to AB. Could someone check to see if I am at least on the right track please? Thank you