Servo Amplifier

[Yuto24 2]

Hi guys

I need some help using the amplifier MR-J4W2-44B, im trying to connect it to a FX5U but I dont know were to send the output for the pulses for the amplifier, and the diagram doesnt show any servo ignition or pls-sign as other amplifiers that I used before this one.

Thanks for reeding

[DaMro 2]

Hi

This servodrive is not using pls,sign. It is SSCNET version. To connect it to FX5U you need additional card FX5-40SSC-S.

[Yuto24 2]

7 hours ago, DaMro said:

Hi

This servodrive is not using pls,sign. It is SSCNET version. To connect it to FX5U you need additional card FX5-40SSC-S.

I have the card here, how can I turn on the amplifier to run the servo?

[Crossbow 295]

There is a manual explaining the programming of the SSCNET module, recommend you start there.

[glavanov 40]

Read this first...

FX5-40/80SSC-S StartUp manual: https://www.allied-automation.com/wp-content/uploads/2015/05/MITSUBISHI_manual_FX5-40SSC_startup.pdf

FX5-40/80SSC-S Application manual: https://www.allied-automation.com/wp-content/uploads/2015/05/MITSUBISHI_manual_FX5-40SSC_advanced.pdf

FX5-40/80SSC-S Advanced Synchronous Control manual: https://www.allied-automation.com/wp-content/uploads/2015/05/MITSUBISHI_manual_FX5-40SSC_synchronization.pdf

FX5-40/80SSC-S Hardware manual: https://eu-assets.contentstack.com/v3/assets/blt5412ff9af9aef77f/bltafeba923d7d20a76/617236d9a27c230f0b6e3bc5/288867.pdf

MR-J4W2-_B manual: http://dl.mitsubishielectric.com/dl/fa/document/manual/servo/sh030105/sh030105m.pdf