communication error variables for NX/NJ datalink using CJ areas

[CX_Luigi 1]

getting two NX/NJ plc to communicate through CIP datalink, i can check  _EIP_TargetNodeErr[<IP node address>] and _EIP_RegTargetSta[<IP node address>] for communication problems. However this does not work when the datalink is done through CJ areas. I can get around it in program, but I would better like using an internal variable like the ones above. So far I didn't found anything in the documentation, are such flags existing and available as system variables?

Thanks

[photovoltaic 140]

Are you referring to using a CJ1W-EIP21 card or using the CJ areas for FINS?

[CX_Luigi 1]

15 hours ago, photovoltaic said:

Are you referring to using a CJ1W-EIP21 card or using the CJ areas for FINS?

CJ area for FINS

[photovoltaic 140]

No system variables exist for communication that isn't cyclic and managed by the system itself. FINS, Modbus, MQTT, and Socket Services all fall in this category.

[CX_Luigi 1]

Got it, thanks

[mike_cheesehead 6]

NX CPU's want to communicate with 8 bites or more if you make them smaller they will error out with CJM cpu's omron has plenty manuals for setting up communication between these 2