Posted 1 Jun 2021 Is there any way to monitor ethernet/ip bus, states or faults and to make an alarm to the panel alarmlist. I am using IO-stations (1734-AENTR) and I would like to monitor somehow the system. I feel that reading the slot status of the 1734-AENTR device is not enough, because it is not possible to monitor all the cards in a slot. How to get alarm on a screen if I lose any station on the ethernet/ip bus? Share this post Link to post Share on other sites
Posted 1 Jun 2021 The statuses are available through the use of a GSV in your program. 1 person likes this Share this post Link to post Share on other sites
Posted 3 Jun 2021 On 1.6.2021 at 4:40 PM, pcmccartney1 said: The statuses are available through the use of a GSV in your program. I need to check possibilities to use that. Thanks! Share this post Link to post Share on other sites
Posted 3 Jun 2021 6 hours ago, Jiggadoo said: I need to check possibilities to use that. Thanks! Word of caution, GSV Instructions take several scans to execute so be cautious how many you execute in a simultaneous manner. It is not as much of an issue with the L8X family as it was with the L5X family. But still worth considering. Share this post Link to post Share on other sites