CJ1W-CT021

[Maher Salem 0]

Hi All,

i want to add an encoder module to the IO table with CJ1M-CPU23 

i can't find module , I need a Help

Thanks in advance

[vasekd 6]

programmer v 9.76 - basic units  - fourth

[BITS N BYTES 66]

Rather than use the the additional I/O module, I would suggest using the built-in High Speed Inputs already available in the PLC.

To use an encoder input you use configure the high speed counter for the type of encoder input.

This is accessed from the Built-In in put settings of the PLC.

Remember that after changing these setting you MUST cycle power to the PLC for them to take effect.

After that you can use the High Speed Counter instructions in the program to monitor the encoder.

Edited 30 Mar 2021 by BITS N BYTES