Posted 20 Sep 2018 (edited) Hello guys, I want some solution for my Mitsubishi Application. I have Visual Studio 2017 (VB.NET) and MX Component 4. I want to connect Q03UDVCPU (Q series PLC) through Ethernet connection. For Read (M0 Flag value and <if M0 is On> then read Barcode information also from PLC.) and write (M1, M10). How can create this transmission program. please kindly guide me. Thanking you. Edited 20 Sep 2018 by felixgmca Share this post Link to post Share on other sites
Posted 20 Sep 2018 Please give it a try first, then post any issues you face. We can help you with problems, but cannot "create" the code for you... 1 person likes this Share this post Link to post Share on other sites
Posted 20 Sep 2018 4 hours ago, felixgmca said: Hello guys, I want some solution for my Mitsubishi Application. I have Visual Studio 2017 (VB.NET) and MX Component 4. I want to connect Q03UDVCPU (Q series PLC) through Ethernet connection. For Read (M0 Flag value and <if M0 is On> then read Barcode information also from PLC.) and write (M1, M10). How can create this transmission program. please kindly guide me. Thanking you. Go to C:\MELSEC\Act\Samples there are VB.Net example that you can modify it. 1 person likes this Share this post Link to post Share on other sites
Posted 27 Sep 2018 I used the following source as sample. Thanks for good starting solution. C:\MELSEC\Act\Samples\Vb.NET\SampleDot And I need your valuable suggestion for Q03UDVCPU (Q series PLC) simulator. Could you please give any opinion? Share this post Link to post Share on other sites
Posted 27 Sep 2018 11 minutes ago, felixgmca said: I used the following source as sample. Thanks for good starting solution. C:\MELSEC\Act\Samples\Vb.NET\SampleDot And I need your valuable suggestion for Q03UDVCPU (Q series PLC) simulator. Could you please give any opinion? Please follow this instructions. 1. Install GX Works 2 that include GX Simulator 2. 2. Go to folder C:\MELSEC\Act\Utl and run ActComm.exe. 3. Create logical station number by wizard and use GX Simulator 2. 4. Create some project in GX Works2 with Q03UDV and run simulator. 5. Change station number in your VB.Net program to which use GX Simulator 2. 6. Run software if setup correctly program would connect with GX Simulator 2. 7. After finish your project create logical station number by wizard and use Ethernet Board -> CPU Module then input PLC IP Address. 1 person likes this Share this post Link to post Share on other sites
Posted 27 Sep 2018 Thanks for the instructions. I shall try now. Share this post Link to post Share on other sites
Posted 1 Oct 2018 Thanks a lot. Process working successfully with simulator. Share this post Link to post Share on other sites