Posted 5 Sep 2014 hi guys, is that possible to put 2 cclink (QJ61BT11N) in a same CPU module? 1st cclink comunication with - A area 2nd cclink comunication with -B area Good Day =) Share this post Link to post Share on other sites
Posted 5 Sep 2014 Absolutely. I have a customer with two or three in the same rack. Share this post Link to post Share on other sites
Posted 5 Sep 2014 The manual states a limit of 8 CC-Link networks which can be configured via parameters. More can be added than that, but they need code written to configure. Share this post Link to post Share on other sites
Posted 8 Sep 2014 (edited) how should i configuration on parameter ? is it same configuration as usual? Edited 8 Sep 2014 by alvis Share this post Link to post Share on other sites
Posted 8 Sep 2014 Assuming both are Master cards, then they'll be set up essentially the same way. All the addressing should be different, and the remote stations will likely be different, but you can follow the same format. If the second card is a slave card, then you'll be setting it up accordingly. Share this post Link to post Share on other sites
Posted 11 Sep 2014 (edited) is this correct? 1st cc-link = link to 12 nos modules 2nd cc-link = link to 13 nos modules Edited 11 Sep 2014 by alvis Share this post Link to post Share on other sites
Posted 11 Sep 2014 Um, yes? Since I don't know what's in your PLC Rack, what's connected to the networks, or what you are trying to accomplish, I'm not sure what kind of response you're expecting. Share this post Link to post Share on other sites