Upgrade C200H to CS1

[nguyenthanhcanh 3]

Hello whole mrplc family, I have a plan to upgrade C200H system to CS1. My current C200H configuration: 1. C200H-CPU01 2. C200H-RM201 + some G72C-VID16 + some G71-OD16 3. C200H-NC112 Plan to upgrade to new CS1 configuration: 1. C200HW-PA204 2. CS1G-CPU42H 3. CS1W-BC083 4. Keep C200H-RM201 (address change from [200] to [3100]) 5. Keep C200H-NC112 Have any problems? I have refered the CS1 catalogues: - First, look up old CS1 catalogue (Cat.No.P047-E1-1): C200H-RM201 & C200H-NC112 are supported by CS1 - Next, look up new CS1 catalogue (Cat. No. R090-E1-04): C200H-RM201 & C200H-NC112 are not supported by CS1. - Finally, open a new CS1G-H project with CX-P V7.11, look up O/I table: C200H-RM201 (SysmacBus Remote Master) & C200H-NC112 are supported. Please give me an advice. Thank you. Edited 10 Jun 2008 by nguyenthanhcanh

[bluebyu 4]

Looks like you have done your research. The Nc card will also have it's address change, your CS1 manual will guide you.

[nguyenthanhcanh 3]

Yes, I have researched the manual but I am not sure because new catalogues and manuals of CS1 don't mention to C200H-RM201 & C200H-NC112

[nguyenthanhcanh 3]

Please help me to confirm this job. Urgent!!!

[PdL 71]

Hold on Canh, posts like this will only discourage users to help you out. No need to kick a topic that is only a few hours old. You seem to have planned the job quite well, so you must have had enough time to find this out earlier.... Just wait patiently on a reply.

[PMCR 66]

C200H NC and RM modules are OK. You can always check this kind of thing by making a new CX Programmer project and then adding items to the IO table. Those items that are compatible will be listed as available to add to the IO table.

[PdL 71]

Well there you go

[nguyenthanhcanh 3]

Thanks alot.