Search the Community
Showing results for tags 'fail'.
Found 6 results
GX Developer project does not open
Rajan_UAE posted a topic in MitsubishiHello All, I have a GX Developer project folder file sent by the client. I am not able to open. It opens the GX Developer and says Failed to read the project file. The screen shot is attached. Also the the project is attached. Please help me to open the project. I am using GX Developer version 8.91V 显示器 综合测试.rar
marinecore posted a topic in CX-OneHi, I have CJ1G-CPU42H plc, when I try to backup the program it just fails at step 6 as indicated in the attachment, 6- plc memory ##error aborted ##
Disqualified Redundancy Partner IO Issue?
GuyMiller posted a topic in Allen Bradley / Rockwell AutomationI am investigating a failure that occurred... We have a L62 Processor with RIO and Redundancy, it was reported that a system "failed to stop" this system is started and stopped via outputs channels on an OW16I card on one of the RIO racks. Has anyone had experience an issue with IO not responding as it should if the redundant partner is disqualified? Also, there was a know network issue and the main Ethernet card (Slot 1) did have a communication issue (not the same Ethernet card for the RIO (Slot 3).
sczot posted a topic in MitsubishiHello once again, before I'll dive into mitsu manuals, does anyone of you know if there is some special relay signaling that PLC (FX3GE) have lost communication via MC protocol? Thank you in advance
TWIDO Base Unit Failure
t_c_c posted a topic in Modicon / Telemecanique / Schneider ElectricWe have an install base of about 120 TWIDO PLCs anywhere from 1 to 10 years old with varying configurations, but all using the TWDLCAE40DRF base unit. Lately (over the past couple of years), we've had multiple instances where upon power being removed from the device, and then turned back on, the base unit fails and will not power back up. The typical case is that we turn on the power, a couple of LEDs flash for a brief (< 1 Sec) moment, and then nothing - unit is dead. Just wondering if anyone else has encountered the same thing.
Mr Configurator trouble
Lorenzo1707 posted a topic in MitsubishiHello good morning, I would like to comment on a case, I have a MR JE A 20 driver, it is connected to a plc and it moves a clamp. The fact is that I have variations of distance until it reaches stops and skips the inverter by overload. Well my question is the following, I want to use the mr configurator, I downloaded it, but it gives me a drawback when I connect it I figure as the driver, but in the program it only appears offline, I can not revert, it will be because the Plc Thank you very much for your reply