Search the Community

Showing results for tags 'data address'.

  • Search By Tags

    Type tags separated by commas.

  • Search By Author

Content Type

Find results in...

Find results that...


Date Created

Last Updated

Filter by number of...

Found 131 results

  1. Hello, At the plant I work at there are devices with IP addresses starting with 192.168.0, 192,168.1, and 193.168.2 The SLC in question is on 192.168.2 We would like to access it from our laptops which are on 192.168.0 The laptops have their subnet mask set to 255.255.252.0 and we are able to pull see other controllers on the 192.168.2 network. However, for some reason we can't with this one, not even when I'm plugged directly into the Ethernet port on the controller unless we change our IP address to one on 192.168.2 I believe the subnet mask on the controller isn't set right. Can anyone tell what I'm missing here? Here's an overview of the current settings: Laptop: 192.168.0.20, 255.255.252.0 Controller: 192.168.2.17, 255.255.252.0 Any help would be greatly appreciated. Ben
  2. Dear Sir, I want to read data (Digital Input say X0 (Local PLC) and after some additional logic i want write to Y0 (Remote FX3GE PLC on same network) from one Mitsubishi FX3GE and Write to another FX3GE on the same network. Master PLC IP Address 192.168.0.40 Slave PLC IP Address 192.168.0.50 Atif
  3. I am getting this error. How to resolve this?
  4. Hi dear all , i need some helping .. I used CJ2M cpu31, then i want to send data (example D100 = 2000) to PC ...essentially i want send value 2000 to my PC.. wherein the PC and PLC conect via internet IP .. What should tool/software may i used ? Thanks before ..
  5. I have the following situation; I have a distribution network connecting about 400 RTUs, using 101 protocol to connect to their PDH MUX, which data slot is transported using SDH STM-1/4, to the Primary Substations. Then the primary substations connect to the LDC building using STM-16. At the Control Centre Building where the Front End is located, there is a STM-16 node with some PDH ports, but definetly not 400, so how can I extract this 101 asyncronous data channels to connect them to the SCADA Front End? Note that conversion to 104 is not allowed by the client. Thanks in advance!
  6. How to know what is my Megelis IP address?