Vernon_Ice

did you format the RAM & write to RAM? Make sure all switches is off

Hi Peter I believe you referring to the cam stroke ratio, img2.bmp. How about the stroke setting,img.bmp, can it be changed? Normally, I change the cam data by modifying the stroke setting then press the "Stroke setting complete" button. I want to change the stroke setting using HMI. img.bmp img2.bmp

Hi Guys Need help to check if any1 have the idea of changing the cam data by using PLC (Register, Buffer Memory or Serial Comm.) Thanks

Hi Guys I have a servo MR-J2S-CP trying to perform a DOG Home. I realise that whenever I shift the DOG sensor, the motor will home to the same position. Example: Home sensor @ 0 degree, Home position @ 90 degree Home sensor @ 10 degree, Home position @ 90 degree Home sensor @ 180 degree, Home position @ 90 degree Is there any way to shift the home position to 0 degree? Thanks

Hi I need help on using MR-MC110 PCI positioning card. Can anyone advise on how to write to/read from the register? Thanks

FX to GOt1000 Cable -> SC09 (RS422 to RS232) Software for GOT1000 -> GT Designer 2/3 Driver to install in GOT1000 -> Melsec-FX Option OS install in GOT1000 -> Gateway(server, client) IP add in PC should be also 171.25.10.XXX

Hi anyone with any recommendation? I know it can be done with OPC server, is there any other method of communication? MX Component does not support C# Thanks

Thanks Bros

Can the FX3U, relay output type, be used to control servo drive? Or MUST use transistor type of FX3U?

Thanks Gambit

Slot 0 = 0H Slot 1 = 1H( if Slot 0 is a 16bit module) 2H ( if slot 0 is a 32bit module) Example if I connect 8 x 32 bit module Slot 0 = 0H -> (Top H0) Slot 1 = 2H -> (Top H2) Slot 2 = 4H -> (Top H4) Slot 3 = 6H -> (Top H6) Slot 4 = 8H -> (Top H8) Slot 5 = AH -> (Top HA) Slot 6 = CH -> (Top HC) Slot 7 = EH -> (Top HE)

Problem is that the program is stored in EEPROM which require to stop PLC in order to edit the program. I want to store the program in RAM so that I can online edit the program while the PLC is running. But when i create a new file, it only allow me to write to EEPROM, not RAM. With EEPROM attach to A1SH PLC, does it "bypass" the RAM & only EEPROM is accessible? Thanks

I'm using GX Developer Version 8 I can do online monitor but i cant online write. I have to stop PLC then write to plc. Is it because I have EEPROM attach to the PLC?

Hi I need help in online editing while PLC in in run mode. Currently, I need to stop the PLC then can write the program. Why is it writing to EEPROM? Thanks