cHud

MrPLC Member
 View profile  See their activity

  • Content count

    389

  • Joined

  • Last visited

Posts posted by cHud

  3. Posted

    On 9/11/2019 at 2:18 PM, akbar_torkashwand said:

    YES. I have this software. I connect  mini USB between PC and HMI. Driver is OK in device manager. But I have this error when I want to upload program from HMI .

    What should I do?

    USB.png

    This is not the vijeo designer software. This is data manager which is used to upload or download logged data. 

    As mentioned before if the include editor project was not selected when the program was downloaded then the program cannot be uploaded

  13. Posted

    if i remember correctly you need an os/2 operating system.........i think you can make a virtual pc and os/2 can be downloaded.....Cable wise i am not to sure but i think it was a standard rs232 cable and you still get the wiring of it on google......The last tsx17 conversion i did was converting from pl7 pro to pl7 program and then converting the pl7 program to unity....all worked.... Only thing that was not iec was the timers

  18. Posted

    Just to add...no need to use the run time installer. You install directly from within vijeo designer and specifying to download to ethernet. And when the download starts it will notify you if the runtime needs upgrading which it will do when you select yes.

    Make sure you put your patch lead into the ethernet port and not the rs485 port

  19. Posted

    Ok i was mistaken....Looks like you can use vijeo designer or vijeo xd.

    That screen is what all the vijeo designer hmi's show when 1st powered. You could download with usb but you need the schneider cable. Or if it has a mini usb port any 5 pin mini usb cable should do. The easiest is to press the network icon on the top right and enter the ip you want. Then in vijeo designer specify that your target is that ip and then download to ethernet.

  22. Posted

    HMID range is programmed with vijeo xd...........Unfortunately i havent done a vijeo xd hmi yet but for what it is worth you can normally set the ip address in the hmi runtime settings when it is a new screen or you must setup a modbus driver in the software and then specify the ip address of the plc and hmi in there and download via usb to the hmi

     

    This link is for using a m221 plc but it at least shows you where to setup hmi settings in vijeo xd

    https://www.youtube.com/watch?v=mVKj75cykQU

  25. Posted · Edited by cHud

    Ok 1st things 1st. Do you have the driver installed. In your device manager in windows does the unitelway driver show under comports when the cable is plugged in?

    If yes check the port number. Then go to your modicon drivers manager----------then unitelway----------the setup or config or something--------then a popup will appear showing your different instances of the driver------add one or select an existing one and edit---------make sure the correct com port is selected.

    Then hit ok and then apply-----your driver should reset and then show reset was ok.

    Now open the software and under plc select address settings. Make sure unitelway is selected and address must have SYS in it.

    Hopefulle it works then