full time
MrPLC Member-
Content count
8 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Calendar
Everything posted by full time
-
While trying to connect to a cpu 434-12a 486 controller i get an error code message ol9-1672 ,however if I look at lower right hand coner it says " established connection to controller ".
-
when trying to establish communication between my laptop (VISTA) and the omron plc C1000H. I have to use a USB to serial adapter connected to the cable we normally have connected with before. I cannot connect to PLC. I check device manager to and it recognizes the adapter and there both set to the same com port. I don't know if its the vista operating system or what. Does anyone have any suggestions.
-
I am new to analog , so, just need basic understanding of how to program a simple analog input, using twos complement, Thanks bill
-
well, I am using micrologix 1500, I'm looking for basic analog programming instructions . sometimh for a beginner .I like to learn THE RIGHTWAY, not the way " old joe does it "
-
Im trying to configure a micrologix 1500, with 1) 16 pt input card 2) analog in 3) analog out .So i click I/O CONFIGURATION IN RSLOGIX WITH RSLINKS CONFIGURED TO RS 232 DF 1 . click auto config and the message keeps coming up COULD NOT READ I/O CONFIG FOR SOLT 1 .This is the the problem .Note I have estabilished communication.