full time

MrPLC Member
  • Content count

    8
  • Joined

  • Last visited

Community Reputation

0 Neutral

About full time

  • Rank
    Newbie

Profile Information

  • Country United States
  1. While trying to connect to a cpu 434-12a 486 controller i get an error code message ol9-1672 ,however if I look at lower right hand coner it says " established connection to controller ".
  2. omron communication

    when trying to establish communication between my laptop (VISTA) and the omron plc C1000H. I have to use a USB to serial adapter connected to the cable we normally have connected with before. I cannot connect to PLC. I check device manager to and it recognizes the adapter and there both set to the same com port. I don't know if its the vista operating system or what. Does anyone have any suggestions.
  3. omron

    is there a way to read a c1000 using some kind of ehternet conversion cable besides RS- 232 Thanks
  4. new to analog

    well, I am using micrologix 1500, I'm looking for basic analog programming instructions . sometimh for a beginner .I like to learn THE RIGHTWAY, not the way " old joe does it "
  5. I am new to analog , so, just need basic understanding of how to program a simple analog input, using twos complement, Thanks bill
  6. Im trying to configure a micrologix 1500, with 1) 16 pt input card 2) analog in 3) analog out .So i click I/O CONFIGURATION IN RSLOGIX WITH RSLINKS CONFIGURED TO RS 232 DF 1 . click auto config and the message keeps coming up COULD NOT READ I/O CONFIG FOR SOLT 1 .This is the the problem .Note I have estabilished communication.
  7. C200HE

    well, I cant seem to communicate with the PLC , I tried straight through, that does not work. Does anyone have any pin out configurations I can try?
  8. C200HE

    Help, trying to set communications with an C200HE, does anyone know the right pin out . maybe I need to buy a cable ? any Ideas