ollyhutsby

MrPLC Member
 View profile  See their activity

  • Content count

    2

  • Joined

  • Last visited

Community Reputation

1 Neutral

About ollyhutsby

  • Rank
    Hi, I am New!

Profile Information

  • Country United Kingdom
  1. pturmel liked a post in a topic: Linmot drive to nx1p2-9B24DT1 through ethercat
  2. problem solved, It was a run mode parameter setting inside the linmot drive.
  3. I am currently trying to control a linmot c1150 servo drive through ethercat. i have all the comms setup, and i am getting live status updates from the drive.  when i use a move command FB, MCMove or MCjog, the cmd position will move, however the act position stays the same. There is no error on my FB and the axis appears as if it is moving.  Has anyone had any experience setting up a Linmot? or had a similar issue when setting up a third party drive?