11 posts in this topic

Does anybody know where I can get a key for the S6 pro16 console?

 

Even a side picture would do as I can probably make one.

 

I have the console, but without the key it's a paperweight.

Share this post


Link to post
Share on other sites

See attached.

S6Key_1_A.jpg

S6Key_2_a.jpg

Share this post


Link to post
Share on other sites

Watch the addressing, did this is CX-Programmer and some of the addresses don't work.

LD 0.03
OR 0.04
OR 0.05
LDNOT 0.10
ORNOT 0.08
ANDLD
AND 0.09
LD 0.03
AND 0.00
AND 0.01
ANDNOT 0.09
ANDNOT 0.06
LDNOT 0.03
AND 0.04
ORLD
LD 0.12
AND 0.13
ORLD
ANDLD
LD 0.08
ANDNOT 0.07
ANDNOT 0.11
ANDNOT CNT001
OR 0.03
ANDLD
ANDNOT 0.11
ANDNOT 0.09
OUT 0.12
OUT 0.13


gtsuport

Share this post


Link to post
Share on other sites

Posted (edited)

I am re-posting. The last ANDNOT 11 was supposed to be AND NOT 111. 

OMRON SEQUENCE MR PLC.pdf

Here's the entire program if anybody feels ambitious. I give up! I can't translate enough of this to make a difference.

OMRON PRESS PROGRAM.txt

Edited by stickman47
Add full program listing

Share this post


Link to post
Share on other sites

Let me get some sleep and I will do it for you.

Share this post


Link to post
Share on other sites

Did you get your problem solved and are you trying  to translate to CX Programmer?
?

Share this post


Link to post
Share on other sites

No, I am trying to draw the ladder based on the program list.  CX is changing the addresses. My address is 111, CX makes it 1.11. Some of my references do not translate to CX. HDM does not translate in CX. I just want to understand what is here so I can make adjustments. this controller is running a small punch press. The press is not stopping at top dead center. I need to adjust something in the program to offset this difference. There are no cams and the proximity switch that is connected to the HDM terminals has no adjustment. My boss wants to rip the whole thing out and have me install a Cieco press control, but that is $5,000! 

Share this post


Link to post
Share on other sites

I think he just needs to understand how the HDM works.  He does not want to replace the S6. I am at the  doctors office and will get back on it when I get home. I have got the ladder halfway done.  Syswin is better for converting this one.

Share this post


Link to post
Share on other sites

Posted (edited)

Or this:

Omron S6 Manual

See printed page 42.

gtsuport

Edited by gtsuport

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now