Posted 1 Nov 2016 Dear guys, I uploaded program from CQM1-41E PlC but when i downloaded it in other CQM1-41E ,it was not working.Please guide me where i m doing mistake? Thanks in advance Share this post Link to post Share on other sites
Posted 1 Nov 2016 Did you upload Setting , Expansion Instruction and the memory (HR, DM, TC) from running CQM1? Share this post Link to post Share on other sites
Posted 1 Nov 2016 i clicked on direct online then a pop up window generated that do you want to transfer i/0 table and special unit on pc then i checked on it.no option of setting and memory option there for uploading in cx-one????can you guide me plz. Share this post Link to post Share on other sites
Posted 2 Nov 2016 21 hours ago, Aman12 said: Dear guys, I uploaded program from CQM1-41E PlC but when i downloaded it in other CQM1-41E ,it was not working.Please guide me where i m doing mistake? Thanks in advance What is not working? Is the Error LED on or flashing? Is the Run LED on? Share this post Link to post Share on other sites
Posted 2 Nov 2016 Also need to upload the Data Memories from the original CPU. 1 person likes this Share this post Link to post Share on other sites
Posted 3 Nov 2016 OK bro thanks for guide me.I have an other problem that what is fatal error and i/o bus error??? Share this post Link to post Share on other sites
Posted 4 Nov 2016 Try re-seating the I/O modules. It's also possible one of them could be bad. Do you have a right side end cap? Share this post Link to post Share on other sites