Posted 17 Sep 2015 Hello, Can someone tell me which cables I have to use go online with CJ1M and CPM2A? Can I make them or buy them? And do i use CX-one to go online with the controllers? Any help would be appreciated Thank you for reading. Share this post Link to post Share on other sites
Posted 17 Sep 2015 Both CJ1M and CPM2A support Omron's DB9 hardware. (It is not identical to a PCs DB9 hardware.) Therefore you can construct your own cable to use with CX One. See attached diagram. C200HS-CN220-EU Serial Cable.pdf Share this post Link to post Share on other sites
Posted 17 Sep 2015 Hello Jay, Thank you for the quick reply ! So this one cable will work for both of them right? Thanks for your time ;) Share this post Link to post Share on other sites
Posted 17 Sep 2015 If it is an Omron device with a 9 pin port on it, then the cable that Jay specified will work. Yes. Share this post Link to post Share on other sites
Posted 17 Sep 2015 I check the controllers and CJ1M's port is connected with XM28-09 cable abd CPM2A's port is connected with "NUVAL CV9GY". Where are these cables connected to? Do i still construct my own cable to use with CX One? cant i use the cables those are connected with the controllers? Share this post Link to post Share on other sites
Posted 17 Sep 2015 The XM28-09 looks like it has a 25 pin on one end. I guess that you could adapt that with a 25 to 9 pin converter and give it a try. I have no idea what the NUVAL Part number is. You could always give it a try.... Share this post Link to post Share on other sites
Posted 17 Sep 2015 Thanks Michael, I guess if it doesnt work i can make my own cable since it has 9pin port. Thanks alot !! Share this post Link to post Share on other sites