pycathiu
MrPLC Member-
Content count
16 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout pycathiu
-
Rank
Sparky
Contact Methods
- ICQ 0
-
i am afraid that you can't connect it to CPM2A directly. as the attachments
-
any one know the difference of the 3G3RV@6SE70? because i havn't seen the power measure machine,and i don't know the 6SE70. is it has more function than 3G3RV?
-
AC NET=power supply the translate fig
-
one of our customer have a project to use OMRON 3G3RV to replace the siemens inverter 6SE70,the device is use to measure the power of the AC net.can i use the 3G3RV to replace the 6SE70?
-
you should setup it's system programm again.
-
my suggestion is: 1.if you have enough money,you can buy a CS1W-CIF31,OMRON product,no problem;(about $200) 2.buy a PCMCIA-232 adapter,is same to a 232 port in mainbroad.i buy one,no problem.(about $40)
-
We also have this problem in setup CX-PROGRAMMER&NS-DESIGNER,when the cx-server vison of CX-PROGRAMMER is higher than the cx-server of NS-D,you should install ns-d first,then install cx-p.And you should install them completely. otherwise the software will not run well... finally,my suggestion is to setup the cx-one,almost all of the omron's software is in it.
-
this PLC is product in china shanghai
-
as upper said,the CT001 setting words are on DM area,you should copy them to the new PLC.and you should creative the I/O table
-
this can be direct connect with the PC without any conversion cable
-
maybe you should use the instruction DATE in programm,and use a start bit before it.on NS,set the parameter of the DATE,and start the start bit of the DATE.
-
The newest FB.refer to it. sorry it is too big.i can't upload it
-
hi,this is the programm of cpm2a use peripheral port & RS232c PORT to communication with V7.refer to it CPM2AH_Inverter.rar