Rodney

try here www.bihl-wiedemann.de/englisch/down/downldeds.htm Rodney

Hi PLC70 For PC connection you require a MPI device and for the PG connection the PG has a built in MPI port so it should have a cable for the connection. Rodney

Also for the SLC range of P.L.C's

I have to agree with Crossbow as always Rodney

Not sure if this helps manual for the F2-232GF1 But I have always used the F2-20GF2 as Crossbow mensioned with the SC03 devise. Rodney JY992D18501-A.pdf

Steve it is the same thing Rod

Hi Steve When you insert the im153-1 into the hardware config you will see it as the backplane as you call it. You then insert your I/O as you want it. Regards Rod

Phil In my message yesterday I mentioned that you can see the vertical contact in the power line when you are in monitor mode. I can see from your screen shot that you are in write mode. You will also see it in read mode. Regards Rod

as Kaarte_t has said you will have to have a terminating instruction so the MC knows were to end. The instrucion would be MCR N0 with no contacts ptior to it. you will also see a contact in the vertical power line when in monitor mode N0 M300. Rodney

this is the Mitsubishi IEC programming software. where it is progammed as in a tag form but the Mitsubishi still use the X and the Y which is the software downloaded to the P.L.C. But the IEC as Crossbow mentioned has the X and Q

Not to try and confuse the question however the I and Q were for the english speaking countries.. The german is E for inputs and A for outputs. Rod

Open one of the blocks eg OB1 options reference data display should the reference data be = regenerated create cross reference then a cross reference will be generated and you will see all addresses and where they are used Rodney

Why not try EBAY with its Global market Rodney

TW Try this SIMATIC NET CP 5711 Rodney

Simon you should be able to download the manuals from Mitsubishi UK web site Rodney

PMCR If you do a search in this forum you will find a number of topics on Prodave Protocol Rodney

G X Developer is for Mitsubishi P.L.C programmining and not Omron.

Try here support.automation.siemens.com/TW/llisapi.dll/csfetch/1... Siemens Web Site has a large amount of information even for S5 P.L.C,s

PLCMentor.com and then training vidios Rodney

IO_Rack Thanks for that I will check it next week. Rodney

I am trying to upload a program from the above screen. I put the screen into transfer mode but when I press enter on my computer to receive the program the screen alarm goes off and reception error is shown on the display. I am using NT software to upload the program. Thanks in advance for any suggestions. Rodney

Walid Thanks for your reply just prior to trying to backup the NT30 I was able to back up a NT20. Rodney

I always zip the complete folder that G X Developer created Rodney

I have a Latitude D830 and use version 8.80J GX Developer. I have had no problerms with my Ethernet connection. Have you tried talking to Mitsi about this.

Hi doppy if you look in the bottom right corner of your screen it should show insert. If you press your insert key it should change to ovrwrite (overwrite) Rodney