Posted 17 Nov 2006 i wanna use adapter serial (CPM1-CIF01) for my PLC CPM2A, when i plug it to peripheral port the RUN lamp is off, It can turn on only when i connect to PC and click monitor or program toolbar from cx-programmer, then my program can work well, but when i turn off the PLC then i turn on it again the RUN Lamp still OFF, when i unplug the adapter serial the RUN lamp can turn on. Is there any hint to solve it, Thanks Share this post Link to post Share on other sites
Posted 17 Nov 2006 Change this setting and transfer to PLC, power cycle CPU. The default setting for startup mode is Use Programming Console. This means that when a peripheral cable is connected to the peripheral port at startup, it switches to program mode. Share this post Link to post Share on other sites
Posted 20 Nov 2006 It's kinda funny, we were just discussing this. See PLC Law #21. Share this post Link to post Share on other sites