Sign in to follow this  
Followers 0
Guest Guest

omron nt30

6 posts in this topic

access to system menu appears to be blocked have tried pressing two corners of the screen. Is there a way around this?

Share this post


Link to post
Share on other sites
Try again, I do not think there is any way to block this configuration page. Some screens are just tempermental.

Share this post


Link to post
Share on other sites
Could be the #3 dipswitch. If not, disconnect from the PLC and then try the two corners of the screen.

Share this post


Link to post
Share on other sites
Have tried this the only switch on is no6 Also have searched through all screens and cannot find any touch switchs which will access this page?

Share this post


Link to post
Share on other sites
Are you sure about the model? I mean that the NT31 has some software setting in order to disable the configuration setup access, (you need to switch the power on while pressing just one corner), and you will access to the menues.. Hope to be usefull... Mike

Share this post


Link to post
Share on other sites
as previous screens can be tempermental try the top corners and slide your thumbs inwards (after checking dip switches)

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0