Macro Error...

[Learner 0]

Hi, gentlemen... Is me again... This time I encounter one problem that is the 'macro program execution error'... I write in the ns-designer and simulated itself without error... However, when I download to the touch screen and linked up other devices then the problem start coming out... the error is something like this, 'macro execution error... check the objeck id... check the registration host'... Because, my senior write the program and I not so sure what is needed to do the setting from the plc side or is there something I missed out? I check the manual but not much helps can get... So, I just publish over here and hope the experts here can give some comments or some ideas or some hints that I can search for the root caused... So, hope someone can help me out... Thank you...

[Jay Anthony 118]

This indicates that you have refernced either a serial port or and ethernet port which has not been setup. Check your system settings for CommAll and see what you have enabled for communications