Posted 28 March Hello everyone, I am studying Mitsubishi R-Series PLC with GXwork3. I don't really understand communication using CC-Link. Below I have the module configuration that I use. My hope is that the Digital operation value of the AI module is stored at addresses D0-D32. and I sent AO to address D100-D132. can someone guide me to give me an example of how to set parameters and create a program. thanks you Share this post Link to post Share on other sites
Posted 2 April Maybe you should start in steps and get network running with the stations. after that refresh the correct Registers/adresses. And than the need programming There is an e-learnig for CC-Link. you should follow this first https://www.mitsubishielectric.com/fa/service-support/global/e-learning/pdf/eng/1-CC-Link_iQ-R_na_eng-A.pdf Share this post Link to post Share on other sites
Posted 3 April Thank you for the advice. my problem has been resolved Share this post Link to post Share on other sites
