Can't connect to MQTT-broker from Sysmac Studio

[Foolio 0]

I have a problem connecting Sysmac Studio to local MQTT-broker (ErrorID: 2003). Sysmac Studio is running in simulation mode.
Through MQTTfx, I connect to the local broker without problems, but I can’t connect from Sysmac Studio, although I use the same port, broker ip.
Thanks in advance for any help in solving the problem :)

[pturmel 160]

As far as I can tell from the documentation, Sysmac Studio simulation does not permit network connections or EtherCAT connections or EtherNet/IP connections in the simulation.  You can only perform integrated simulation with an NA HMI that is part of the same project, or an NS HMI in CX-Designer.

I'm pretty sure you will need a real controller to test MQTT.

[photovoltaic 121]

4 hours ago, pturmel said:

As far as I can tell from the documentation, Sysmac Studio simulation does not permit network connections or EtherCAT connections or EtherNet/IP connections in the simulation.  You can only perform integrated simulation with an NA HMI that is part of the same project, or an NS HMI in CX-Designer.

I'm pretty sure you will need a real controller to test MQTT.

Correct. It won't talk to the outside world.