Communication Module

2 posts in this topic

Need your suggestion to find out the desired solution. basically I have Mitsubishi Communication modules attached in my machine. The last module gives error sometimes after 
running 2 to 3 hours fine but after that it gives communication fault error in last communication module. However I have checked the cable and DIP swithces it all fine  but if I changed the resistor it works fine for about 4 to 5 hours then after sometimes it again shows communication fault. So plz suggest me which value resistor should I place  in last communication module and what are the possible causes of that problems ?

Communication Module: Mitsubishi AJ65SBTB

Share this post

Link to post
Share on other sites

110 Ohm 1/2W

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now