Posted 25 Oct 2018 Hello! i am having a weird problem with this expansion CP1W-8ER. using the switch box utility i have no trouble forcing ON and Off the Output for example 101.01 but when i try to add this address to a line in CX programmer. it appears like a Work output not a physical one Any suggestions? Attached are some pics Thank you for your help Share this post Link to post Share on other sites
Posted 25 Oct 2018 9 hours ago, theinquisitor55 said: but when i try to add this address to a line in CX programmer. it appears like a Work output not a physical one This is correct. CX Programmer does not know if it is a physical address or internal because the CP series PLCs do not require an I/O Table. (I/O is 'plug and play'). Notice the project tree does not contain the item, "IO Table and Unit Setup". The only exception in the CP series is the CP1H. Share this post Link to post Share on other sites
Posted 25 Oct 2018 2 hours ago, IO_Rack said: The only exception in the CP series is the CP1H. And the CP1H would still show CP1W Expansion modules as Work. Only the CJ modules attached to the side would show in the I/O table. Share this post Link to post Share on other sites
Posted 25 Oct 2018 I assumed it would show because of the I/O table. Thanks for the information. Share this post Link to post Share on other sites