Posted 21 Apr 2017 Thanks for all the help when i connect another Slave Plc Cpu is FX3G40MR Slave Plc CClink Card is FX3U-64CCL to my network where should i find received and send data in master Settings are done same in master no of station to 2 and quadruple for slave station switch is on 9 and station no switch is on 3 Share this post Link to post Share on other sites
Posted 21 Apr 2017 (edited) Just add the slave in the stations information setting. As your first slave is three stations. the next should one be station 4. (rotary switch) When the data from the first slave end that is where the data from the next slave begins. The Slave programs would be the same. Edited 21 Apr 2017 by Gambit Share this post Link to post Share on other sites
Posted 21 Apr 2017 ok in slave for read and write i am using "to" and "from" command photo is attached i just explain the factor K176 in FROM command and K304 in TO Command. Share this post Link to post Share on other sites
Posted 21 Apr 2017 I have to connect one input and one output card to my master plc but when i connect it in sequence of [power supply][cpu][cclink][input][output] it gives error and i cannot on my output card when i change my sequence to [power supply][cpu][input][output][cclink] it shows parameter error 3105 c112 what changes has to be done to work both properly thanks for the help Share this post Link to post Share on other sites
Posted 22 Apr 2017 Did you change the IO assignment in the parameters to reflect your additional cards correctly? Share this post Link to post Share on other sites
Posted 24 Apr 2017 yes now its working properly very help full if you tell me factor K176 in FROM command and K304 in TO Command. i found that command in one of the sample programs Share this post Link to post Share on other sites
Posted 25 Apr 2017 It's the buffer memory adres you want to read the data from Share this post Link to post Share on other sites