CP1L-E Socket service porgamme

[niyaz 0]

Hi Guys, i am trying to send the data to pc through tcp/ip socket service programme.I am using CP1L-E plc. . I am facing problem in connectivity it self. not able to connect to my pc. ( plc is client and my pc is server.bmpserver). Always showing listening only. i am using port number same in both sides. using OPEN SOCKET Funtion block in plc side.

after monitoring i found A47.0 bit is ON and A567.14 is turn on which means that result storage error falg. i am facing problem to recover this.

 Thanks in advance.

[Michael Walsh 265]

Post your code.

[niyaz 0]

server.bmpserver.bmp;

PLC2.bmp;

PLC1-(IP SETTING).bmp;

tcp socket1.bmp 

Hi, Please find the attached programme. i am using this open socket programme to connect with my server pc. ( SERVER PC IP ADDRESS 192.168.25.7).

Thanks in advance.

Edited 27 May 2016 by niyaz

[Michael Walsh 265]

Please post the code.  It will have a .cxp extension.

[niyaz 0]

Hi, Please find the attached programme . Thanks in advance

 

tcp socket.cxp 

[Michael Walsh 265]

You open the socket to 192.168.25.5 in the code above.  In the comment above, you said that your PC server was 192.168.25.7.

[niyaz 0]

Sorry. In my pc (server) side ip address is 192.168.25.5 only. i tried so many times but not able to communicate. In my programme after i turn on the socket no.1,  monitored the A567(TCP/UDP Socket No.1 status). First its showing A567.01  turns on , after few seconds  A567.14 (BIT -14 )turns ON  and A567.01 turns off (Bit-14 means - results storage error flag).  

may i know how to trouble shoot for this problem. thanks in advance.

Edited 30 May 2016 by niyaz

[Michael Walsh 265]

I used your ladder code on my PLC (only changed IP Addresses) and I was able to open the port, send some data, receive data and then close the port.  I have no issues here.  Perhaps you should try a different test Client.  I am using a shareware called TCP Client / Server.

[niyaz 0]

okay thank you. Now its working with the other TCP client server software.is it possible to turn on all 3 sockets together and want to send the data by using all 3 sockets .For that , how can i split my programme . I am not getting exactly how can i use open socket function block for all 3 sockets at a time if possible. For all 3 sockets need to use different port numbers?

Thanks in advance.

Edited 1 Jun 2016 by niyaz

[Michael Walsh 265]

Yes.  Three sockets, three ports.

[HARSHAL 0]

I AM NEW IN PLC PROGRAMMING. I AM TRYING TO COMMUNICATE TWO PLC OVER ETHERNET. I USED SAME POSTED PROGRAMMED. 

THE PLC 1 IS ON 192.168.250.1 PORT NUMBER 9600. AND PLC 2 IS ON 192.168.250.12 PORT NUMBER 9600. I AM TRYING TO OPEN TCP SOCKET FROM PLC BUT, I COULD NOT GET DONE BIT. AS WELL, WHEN I SEND MASSAGE FROM SEND FUNCTION, IT SHOWS THAT SOCKET IS NOT OPEN YET. 

CAN YOU EXPLAIN ME MORE ABOUT THIS FUNCTION. AND HOW CAN I COMMUNICATE BOTH PLC WITHOUT ERROR. 

THANK YOU