HARSHAL

MrPLC Member
 View profile  See their activity

  • Content count

    5

  • Joined

  • Last visited

Community Reputation

0 Neutral

About HARSHAL

  • Rank
    Newbie

Profile Information

  • Country Australia

  1. MODBUS TCP COMMUNICATION WITH SEW MDX61B DRIVE

    HARSHAL replied to HARSHAL's topic in CX-Programmer

    It is working now. 
  2. Hello everyone    I am working on modbus TCP protocols to communicate between SEW drive and Omron PLC CP1L-EM. I am following modbus TCP function block from Omron, But i have updated that block because of is not fit to SEW modbus communication. Currently, I am sending a control work to SEW but I am getting error on Modbus TCP from SEW drive, which is invalid data. So I am looking your help is you work with SEW drive before and communicate over modbus, then please let me know how to make a data string for read and write (SEW Drive function 23). I am using 3PD data structure.    Thank you
  3. hello Every one,    I am using a CP1-L PLC and want to communicate to domino ax350i printer over TCP/IP socket programming. For socket programming, I used Omron Function Block CPU012_SendCommand.  I defined network ID and node address. However, I am getting 0502 error which means routing table is not set yes. So, how can I set routing table for both devices?. my PLC on 192.168.250.1 and Printer is on 192.168.250.123 node 7000.    Can any one suggest me best way to do.  Thank you   attached file is for what I did in setting and program for the communication.      
  4. CHECK YOU WIRING 

  5. HI MICHAEL WALSH
    THIS IS HARSHAL PATEL. I AM NEW IN OMRON PLC PROGRAMMING. I WANT TO COMMUNICATE TWO OMRON PLC CP1L. BUT I CLOULD NOT OPEN SOCKET FROM A PLC. I HAVE ATTACHED MY PROGRAM WITH IT. CAN YOU LOOK INTO AND UPDATE ME WHAT CAN I DO FOR IT?

    THANK YOU

     

    THE ERROR IS COMMING FROM A567.14 IS REMAIN ON. 
     

    tcp socket.cxp

  6. CP1L-E Socket service porgamme

    HARSHAL replied to niyaz's topic in CX-Programmer

    I AM NEW IN PLC PROGRAMMING. I AM TRYING TO COMMUNICATE TWO PLC OVER ETHERNET. I USED SAME POSTED PROGRAMMED.  THE PLC 1 IS ON 192.168.250.1 PORT NUMBER 9600. AND PLC 2 IS ON 192.168.250.12 PORT NUMBER 9600. I AM TRYING TO OPEN TCP SOCKET FROM PLC BUT, I COULD NOT GET DONE BIT. AS WELL, WHEN I SEND MASSAGE FROM SEND FUNCTION, IT SHOWS THAT SOCKET IS NOT OPEN YET.  CAN YOU EXPLAIN ME MORE ABOUT THIS FUNCTION. AND HOW CAN I COMMUNICATE BOTH PLC WITHOUT ERROR.  THANK YOU