concept 2.6 problem

[arsaam 0]

hi all, i have ploblem for upload from plc &occre  this error please help      my plc is modicon tsx compact  984-285

[Quant 21]

Hello arsaam, I' not sure, but maybe your plc have LL984 firmware, so you can't upload you IEC application in to this plc now.

You just need the right IEC firmware for your plc. The sutable firmware you will find in c:/concept/Dat

[arsaam 0]

thx

 

[arsaam 0]

hi all, if The exportable code (machine code) loaded  in  plc, can i  uplaod this cod?  & load in another plc

 

{Process for
loading
Loading the PLC can take place in two parts:
1. The exportable code (machine code) is always loaded onto the PLC.
2. The complete compressed user program is loaded onto the PLC
Note: The user program, consisting of user defined EFBs, DFBs, derived data
types and the program (variables, sections, etc.), is only loaded onto the PLC if in
dialog Options for generating codes (Project → Options for generating
codes...) check box contain IEC selection information was activated
beforehand. The option to also load the comments contained in the check box onto
the PLC, thereby making them available as selection information, is available, as
well.
During selection the entire user program can be transferred from the empty project
to the programming device.}

Edited 22 May 2016 by arsaam

[Quant 21]

If your plc doesn't contain upload information (just machine code) then you will be not able to upload anything ;(