How to change value of Omron memory address

[rguimond 1]

The attached .cxp program controls a centrifugal separator. Would someone be willing to take a look at it and tell me what memory address I have to alter to change the analog output that changes when the shoot_relay is energized? As a guide, the value of the output changes from 88% to 100% when the "shoot" is initiated during CIP? I'm not at the location, but I have someone there that can change the value. It's a 48-rung program and should be pretty easy to decipher for an Omron guy... I'm not.Separator-new.cxp.zip Thanks in advance

[Mendon Systems 22]

I was not able to open your zip file.

[vasekd 6]

IT is not .zip. IT is .cxp. Delete zip extension

[Mendon Systems 22]

It looks like the only data that has any effect is a time constant preset that is stored in register D21. There is also another setting stored in D20 for a different mode. This is a classic example of poor documentation making a program that is difficult if not impossible to maintain.

[rguimond 1]

I agree. I didn't write it, but i did inherit it. I managed to figure it out. Thanks.