Noob Question

[Armadillo852 25]

Coming from the AB world, I have a very noob question. I cannot figure this out. Is there a way to change a normally open bit to a normally closed bit? I know I can just insert another bit of the opposite state, but it would be nice to just change it on the rung. Thanks in advance, Corey

[Moggie 17]

Press the "Insert" key. "highlight" the contact then press F2 or F3 F2 = change to "open F3 = change to "close" Press insert key again now - F2 = adds another "closed" contact F3 = adds another "open" contact

[Armadillo852 25]

TY Moggie. I will try it.