Sign in to follow this  
Followers 0
nguyenthanhcanh

Finsgatway 2003 remote network configuration

5 posts in this topic

Hello, I have setup the network: Local PLC Network #1 (Ethernet): Node 1, Unit 0 (IP address: 192.168.250.1) Network #2 (Controller link): Node 1, Unit 1 Remote PLC: Network #2 (Controller link): 5 PLC (Node 2 to 6, all are unit 1 on each PLC) Computer connect to Local PLC (Network #1) I have tested the network and can connect to each PLC via CX-P. Now I'm making an VB2008 project using Compolet V2.1 Please help me to config the Finsgateway to access all PLCs from computer . Thanks

Share this post


Link to post
Share on other sites
OK. I have done it.

Share this post


Link to post
Share on other sites
Good Job! You mind sharing in short how you did this? I am curious!

Share this post


Link to post
Share on other sites
In Fins, change ETN network to 1 (default 0) --> add remote network 2 with relay network 1, relay node 1 In Compolet, set address 2.2.0 (net 2, node 2), 2.3.0, ...

Share this post


Link to post
Share on other sites
Thanks!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0