FX3U-ENET

[ryszard 0]

I have FX3U-ENET in my plc config. What I need is information how to set up ethernet card so that it would connect over the internet, or an example of such setup. Thanks in advance. Richard

[kaare_t 155]

First of all you will need FX Configurator EN to configure the ENET module. Then, assign the correct IP address, subnet mask and gateway (gateway is especially important if you're going to connect to it over the internet).

[Crossbow 295]

You do not need FX Configurator-EN. It can be done completely via TO/FROM instructions or U\G addresses. The configurator simply makes it easier.