Omron Online Editing

[Bob O 8]

I have only used AB so this is my first go with Omron. I need to change DM150 in a CQM1 CPU21 to another value. I was able to get online with this unit and I was able to transfer the DM from the PLC and was able to view it on my laptop. To do the edit is it just the case of type in a new value and send the Selection to the PLC? I wasn’t able to test this as they were shutting down so I will be back in the morning. Also the current value is 98 Hex which is equal to 152 in decimal. The help files mention the Set Value [sV] is in .1 sec intervals so if this is the case then this timer is currently set for 15.2 seconds. I am correct or all wet? Thanks

[BobB 58]

I think you already have a couple of replies elsewhere.

[Bob O 8]

Thank you.

[Randy_xh 0]

DM150 is used for a TIM instruction? if that the value in DM150 should be hex, for example: #10 mean 1 sec, #100 mean 10 sec. you should see #10 or #100 as a BCD number and don't change it to BIN.

[Bob O 8]

I got it working. Thank you for the reply.