devicenet configuration for 1734-adn

[SandyB 0]

I have a 1734-ADN with 3 1734-IB4 modules and 1 1734-OB4E module. I am unsure how to map the input an output size in RS Networx. I have inputs set at 6 and outputs set at 3 but I am unsure why it works this way. I am guessing the ADN take 3 inputs and 2 outputs then add on the modules but I want to make sure that is correct. I have had no luck finding a document that tells you how to set it up, everything I find says enter the correct number of inputs and outputs but never says how to determine this. I am sure it is out there I just haven't found it yet.

[BobLfoot 302]

Chapter 15 of this manual http://literature.rockwellautomation.com/i...um004_-en-p.pdf details the calculation of sizes for input into RSNetworx. And it is specific to point I/O 1734's. Have you checked it out?

[SandyB 0]

Thanks that is what I was looking for

[BobLfoot 302]

Glad to be of help. Post back when you figure out the actual setup and get it working.