Posted 10 Dec 2008 There a lots of useful function blocks on the Mitsubishi website but... they are all for IEC! Can anyone convert these for use in GX developer? Or create a PDF of the raw code so I can attempt a conversion? (I'll promise to upload any successful conversions.) Share this post Link to post Share on other sites
Posted 11 Dec 2008 Download project GX IEC Developer in PLC and upload project in GX DEVELOPER Share this post Link to post Share on other sites
Posted 11 Dec 2008 (edited) I don't have IEC. I've installed the demo but can't open any of the function blocks. Edit : I don't think this is going to work...I'll have to write them from scratch. Edited 11 Dec 2008 by Veganic Share this post Link to post Share on other sites
Posted 11 Dec 2008 all code from gx iec can also be used in gx developer just dump it in a plc and upload the code only thing that can be a problem is that all the code becomes instruction list... Share this post Link to post Share on other sites
Posted 12 Dec 2008 Mitsubishi has very nice (and large) instruction set allowing for lot's of freedom in programming. in fact i don't even bother looking them up anymore. i only use small fraction of this set and make whatever i need using only handfull instructions. i only bother looking new instruction up if it's sometihng to be used frequently. what kind of code or function you look for? Share this post Link to post Share on other sites
Posted 12 Dec 2008 I was 'taken' by the large CC link to Inverter FB's. All that functionality in a box would make for tidy programming. But I'll write one and start with a few functions for now and work up. Share this post Link to post Share on other sites