Posted 14 Mar 2008 Just as a matter of interest, I recently converted the program from a CPM1A to a CP1L. The outputs did not convert to the new address - stayed at channel 10 instead of converting to channel 100. Did it by hand. Share this post Link to post Share on other sites
Posted 17 Mar 2008 And that should of taken all but 5 sec with find and replace.. Share this post Link to post Share on other sites
Posted 18 Mar 2008 Not the point - the conversion should do it for you - there were no warnings or errors either. Share this post Link to post Share on other sites
Posted 18 Mar 2008 I disagree Bob... mainly because the conversion program is probably the same as the one to convert it to a CJ PLC also etc which has dynamic addressing. PLus you can have a different IO config to the CPM. There should be a generic warning stating that the IO addressing mismatch is possible.. agreed. Share this post Link to post Share on other sites