Search the Community

Showing results for tags 'help me in cclink ie field remote device station config'.

  • Search By Tags

    Type tags separated by commas.

  • Search By Author

Content Type

Find results in...

Find results that...


Date Created

Last Updated

Filter by number of...

Found 79 results

  1. I am working on Remote IO panel and plan to use the following components: 1734-AENT 1734-OW4 - qty 2 1734-IE4C I wonder if I need to separate the bus between the relay output module and analog input module? Or anywhere else in this setup? Thanks.
  2. Hello, I'm working with some old Allen-Bradley SLC5/04 systems with 1747-SN modules. The module is located in Slot1. One system is only using the RIO module for a PV1000. How do you know where the "M-Files" for Analog I/O modules and/or Panelviews are located? I see programming using locations such as: M1:1.810 where 60 words are being copied from a Remote I/O PV1000 to some words for the SLC to utilize, but I don't understand why "M1:1.810" was used instead of, for example, "M1:1.800"? I looked and so far cannot find information pertaining to the words other than what is in the User's manual, and it doesn't address this issue. The panelview in my example uses all of Logical Rack 0, Full Rack addressing. Any help would be most appreciated. I have very little experience with the RIO stuff because almost everything I've worked with in the past has been Devicenet.

  3. Combine 2 Machines with CC-Link

    GoTech07 posted a topic in Mitsubishi

    I would like to combine two existing machines with CC-Link. Each machine has a QJ61BT11N set up as its Master Station. The larger machine has 26 remote I/O and 4 remote devices. The smaller machine has 1 remote device (see the attachment). Each are already programmed and running. The larger machine has HMIs that I would like add screens to in order to control the smaller machine as well. The smaller machine would basically just need to send and receive a handful of signals... start, stop, manual, origin, e-stop, fire specific outputs, etc. What would be the best way(s) or simplest way(s) to connect and communicate between these machines? I am open to any advice and ideas. Thank you Machine_Addition_Via_CCLINK.bmp
  4. I need to change the IP address of an existing PLC. Only access I have is remote (VPN). Is there any issue with downloading the same program - with the IP address changed - to the existing processor? Then change the local network range to match, etc...