Search the Community

Hello all, I am trying to get around a lot of manual inputting by exporting a routine and opening it using excel, but looking at the file that excel shows I have a couple fundamental questions 1. when excel opens it and "creates a schema', can I save this in a format that will allow me to import it back into the program? 2. Since I am mapping data using add on instructions, the table excel has created becomes quote complex, with no clear point of reference to where my Input tags are going to go. We are doing this because someone thought it would be a good idea to put a SCADA based control platform over the top of an AB control system, so we have to exchange thousands of points of data back and forth with their system. I created the mapping AOI blocks to be able to manage the file structure a little better in the routines, but that still leaves me with copy and paste thousands of tags into the AOIs. Has anyone developed a good way to create logic, or modify logic using excel? While I can hold my own with utilizing the RS5000 platform, my excel experience is limited. The processor is a 1756-L75 Thanks

Dear Sir, I want to read data (Digital Input say X0 (Local PLC) and after some additional logic i want write to Y0 (Remote FX3GE PLC on same network) from one Mitsubishi FX3GE and Write to another FX3GE on the same network. Master PLC IP Address 192.168.0.40 Slave PLC IP Address 192.168.0.50 Atif

I am getting this error. How to resolve this?

Hi dear all , i need some helping .. I used CJ2M cpu31, then i want to send data (example D100 = 2000) to PC ...essentially i want send value 2000 to my PC.. wherein the PC and PLC conect via internet IP .. What should tool/software may i used ? Thanks before ..

I have had a GE 90-30 CPU331 in my house for 17 years with no trouble at all. I have a problem that I have never seen before. I was editing the program using LM90. I don't know what I could have done in the program to disable an output. Just 1. All the rest of the points in that group on that card still work. I swapped cards with no difference. All of the elements of the rung are true (highlighted). The output is not on or highlighted. The nickname over the output has ONE letter highlighted. The bit in the reference is "0" and is highlighted or "grayed out" (the cursor is not on it). I searched for coil conflicts. I am using this output contact lots of places but only one output. The logic is working correctly when I use another output or %M. This is an isolated output which needs to be in this group (moving it would be awkward). What does a "grayed out" reference bit mean?

I have the following situation; I have a distribution network connecting about 400 RTUs, using 101 protocol to connect to their PDH MUX, which data slot is transported using SDH STM-1/4, to the Primary Substations. Then the primary substations connect to the LDC building using STM-16. At the Control Centre Building where the Front End is located, there is a STM-16 node with some PDH ports, but definetly not 400, so how can I extract this 101 asyncronous data channels to connect them to the SCADA Front End? Note that conversion to 104 is not allowed by the client. Thanks in advance!