Dirk van Zyl

MrPLC Member
  • Content count

    9
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Dirk van Zyl

  • Rank
    Newbie

Profile Information

  • Country South Africa
  1. Mitshibisi to Fanuc Robot with cc link

    it is but usually you need to set up the RX/RY first before you can go to the refresh settings
  2. Mitshibisi to Fanuc Robot with cc link

    thanks will have a look
  3. Safety PLC R08SFCPU

    Thanks I got is working. I am still not 100% on the Shared stranded/safety what is the purpose of this?
  4. Mitshibisi to Fanuc Robot with cc link

    Good day all. I was wondering if someone can assist with the setup between a Mitshibisi R08SFCPU using a RJ61BT11 to talk to a Fanuc Robot controller. So in the screen shot attached i added a generic station because i can not find a file for the fanuc robot. The problem is that it does not give me the option of setting the Rx and RY registers. So not sure how to assign the relevant IO. Anyone with knowledge with this would be great
  5. Safety PLC R08SFCPU

    Not a silly question i was not thinking it through. If you use the standard you can X and Y, and when you do safety you can do SA\X and SA\Y. But if you use the Standard/safety shared is when the error occurs. plus i found a manual that assist a bit better with the setup and programming It is Melsec IQ-R Safety Application Guide in the e-Manual Viewer. Will start coding now and by next week we will have the CPU's to start testing. to see if i understood correctly.   Thanks for the assist.
  6. Safety PLC R08SFCPU

    Thanks for the reply. i still get the following error.    
  7. Safety PLC R08SFCPU

    Good day. Thanks for the reply i did not know about this i will have a look. Much appreciated.
  8. Safety PLC R08SFCPU

    Good day Guys I have been working with Mits for a while but i am new to the GX works 3 setupp. We are looking at using R08SFCPU PLC with a RJ71GF11-T2 for CC-Link IE Field in order to do safety. No i think i understand the normal IO on this device but the safety i just cant get to a point to understand what is happening. When i try to address it SA\X0.... then it says it is invalid. Does anyone have an idea how to do the setup for safety or a manual that describes a bit in detail.   Thanks
  9. Safety PLC R08SFCPU

    Good day Guys I have been working with Mits for a while but i am new to the GX works 3 setupp. We are looking at using R08SFCPU PLC with a RJ71GF11-T2 for CC-Link IE Field in order to do safety. No i think i understand the normal IO on this device but the safety i just cant get to a point to understand what is happening. When i try to address it SA\X0.... then it says it is invalid. Does anyone have an idea how to do the setup for safety or a manual that describes a bit in detail.   Thanks