[Ethernet Communication Between CS1G and RedLion Graphite HMI]

I understand what you're saying @photovoltaic.  I'm working with everything on a closed network in my test area to try to get everything correct before taking it out into the plant, so there shouldn't be any duplication of node numbers, but I'll look again to be sure.  Thank you.

[Ethernet Communication Between CS1G and RedLion Graphite HMI]

Thank you both.

I apologize for the late follow up.

I found that changing the source unit to 0 is correct.

But strangely, I found that I could only communicate with the CS1G if I disconnected the CP1L that is also being used in this project.  I assume this means I am going to be needing a routing table in the CS1G. Is that correct?  Or is that telling me something else?

Also, while desperately changing every setting I could to see what would work, I also discovered that with the CP1L disconnected I can communicate with the CS1G with the destination network and source network fields for the CS1G in crimson both set to either 0 or 4.  Clearly I still have much to learn.

Thank you again for your help!

I'll continue to update this as I progress in case it helps someone else in the future.

 

[Ethernet Communication Between CS1G and RedLion Graphite HMI]

I am attempting to establish ethernet communication between a CS1G PLC with CS1W-ETN21 card and a RedLion Graphite HMI.  I have effortlessly established communication with various other PLCs and Graphite HMIs in the past, but the CS1G is kicking my butt. 

Attached are 5 pictures showing what I have. 

I would greatly appreciate it if anyone could take a look and give me a hand getting this to work.

Thank you.

[Ethernet Communication Between CS1G and RedLion Graphite HMI]

I am attempting to establish ethernet communication between a CS1G PLC with CS1W-ETN21 card and a RedLion Graphite HMI.  I have effortlessly established communication with various other PLCs and Graphite HMIs in the past, but the CS1G is kicking my butt. 

Attached are 5 pictures showing what I have. 

I would greatly appreciate it if anyone could take a look and give me a hand getting this to work.

Thank you.