kondzik

That is a great idea. Thanks :)

Hello everyone. I have a little problem with making a program on Codesys with timers. When i start the program and switch on the I1 button the signal is detected on e output, but it is not detected on q1 output. Those outputs are connected directly to one line. I attached file with this program into this topic. Does anyone can tell me why this look like it and how to fix it? I changed the extenison from *.prg to *.bmp. czasproste.bmp

I rebooted HMI and PLC many times and it did not change anything. Here are some screenshotes from e designer of program on HMI about PLC communication. I don't know how to check IP address and port numbers of PLC. Can you tell me what kind of program should I use and where can I download it from? In the e-designer there are 2 PLC's but both of them have same port address. 1.bmp 2.bmp 3.bmp 4.bmp

On the new HMI it is the same IP as it was on the old HMI.

It is the same PLC. I just want to change operation panel. I didn't change anything in the PLC program. I downloaded program form the old panel and send it back to new panel. I set the settings on the new panel same as on the old panel but only in the panel's "service mode". I did not change anything in program by e-designer.

Hello everyone. I have a problem. I downloaded project from the e1061 panel and i send it back to a new e1061 panel. Everythink works fine but when i connect this panel same like the old one i can see "err ip stn 35". I have seen similar problem on following link: http://forums.mrplc.com/index.php?showtopic=21068 but on the new panel after sending this program all of the configurations are the same as on the old one. IP adress if ok. I am not sure about the port. Where can i find exactly port of the operation panel and controller. I am using controller QJ71E71. The connection between the panel and controller are by ethernet. If there are any programs to do this please tell me what kind of programs are they. Any help would greatly appreciate!!!!! Thanks a lot!!!