moh

ok thank you

thank you, I have found the problem was my dip-switch off, is that you can tell me how scl use (194) to bring to scale a value from 0 to 10 v for a percentage from 0 to 100% with resoultion 4000. thank you

Hi when I used the last paramettre you my gives A502.05 erh red light is lit .c ' what is the problem

Hello, I did not understand the program that you put my, is what I must do each time before reading an entry or if only initially, is what you tell me how to read the input 1 0a 10 v signal with resolution 4000.unit number , a small program, you know that I am new and I just started with omron thank you . I tried your program with the following change addresses the issue of unity but I do not see the value of the input signal. sparky thank you for the help essaisanalogiquead041.zip

Thank you so much for the information I will read it and if I have, other questions about it it does not bother you to help me

Hello everybody I'm new with omron analog cards, I "ve a CJ1W-ad041-v1 card with a CJ1M-CPU11, my input 0a 10 v is the input A1 and A2, my unit is on # 5 "I need help for all paramettre cio, dm and configuartion card with pictures step by step if possible. thank you for your help and I excuse me for my English is bad

Hello everybody I'm new with omron analog cards, I "ve a CJ1W-ad041-v1 card with a CJ1M-CPU11, my input 0a 10 v is the input A1 and A2, my unit is on # 5 "I need help for all paramettre cio, dm and configuartion card with pictures step by step if possible. thank you for your help and I excuse me for my English is bad