Automatoes

Now it works... Fun, that would work with DINT didnt?" Since I had configured words as DINT on the PanelBuilder too...well... Tks, Automatoes

Sure, there is... Refrigeracao_REV01.ACD PROVISÓRIA.PBA

Well, I have made some advances, but it still doesn't works, let's see. Controllogix: The IHM already are on the 1756-EN2T scanner, and the instances are configurated to AI1:X to IHM_REFRIGERACAO:I.Data[X] and AO1:X to IHM_REFRIGERACAO:O.Data[X]. IHM: Already configurated to Eth comm, set the node adress with the PLC adress and the path as 1 0, cause the CPU are at slot 0 and node type as Controllogix 5000. As I wasn't getting status from PLC, I performed a test, throw all available values to the IHM with they respective numbers, for example, throw 0 to IHM_REFRIGERACAO:O.Data[0] until 111 to IHM_REFRIGERACAO:O.Data[111] and I would read 0 at IHM on the AO1:0 until 111 on AO1:111, but, for my surprise, the data was all missed up, what's happening?! I'm sending some SS from the configuration a picture from the result. Best regards, Automatoes

Hummm.. Doesn't works, I throw a speed reference on logic and couldn't find it on Powerflex, I think its some drive network config, but I cant find it...

Sure, I was already sending the 32 bits (DINT) reference from my PLC, but I think the reference parameter are wrong on the drive, I'm using the "Port 4" reference speed, Ill follow these steps and post here in a few moments...

Controllogix 1756-L61 with a 1756-DNB

Houston, we have a problem!! I have here four PFlex 753 on Dnet, I just cant send to them the speed reference throw the Dnet connection, I can turn them on and off and get some status from them, but I cant send the reference speed, I believe I'm missing some config on the drives, I already try to make some changes on parameter 545 (Speed Ref A), but it doesnt works. Best regards and sry about poor english.

Houston, we have a problem!! I have to configure a PV1000Color on Panel builder, to comunicate with a controllogix, but I dont know how!! I already configure the IHM on the Controllogix tree, and configure the comm at IHM, its requesting a "path" when I try to put the Controllogix 5000 as node type, and I cant understand perfectly the concept abou symbolic.xx that I've saw at help, with this symbolic.xx how can I define what is in and outs?! Can anyone post an example?! Tks and sry about the poor english. Best regards untitled.bmp

Hi, My notebook has no serial comm, so I buy a USB 232 conversor, I already use it to comm to RS-232 DF1 channel without problem, but I try to use it with a KFD and it doesn't works, it shouldn't be a port replier?! When I need to comunicate with a Dnet equipment, I'm using the Devicenet scanner at himself, as the equipment already are on the Dnet ring I can found him on RsLinx connecting on the CPU and bypassing throw the Dnet comm. But if I need to configure an isolated equipment, out of a Dnet ring?! Exist any interface to comunicate Dnet with USB connection?! Tks by the way and sry about my poor english. Best regards, Automatoes

Hey, I already have this manual, tks by the way! Best regards, Automatoes

Hi, I would like to know if exist any document with rules about panel wiring for analog inputs and outputs, for example, if we have to use fuse connector on the 24V output, or at the voltage return, if we can just use simple connectors, without fuse, etc. Best regards, Automatoes